In this article, we will give you a quick introduction on how to make full use of the filters feature in PAM.
Filters are useful in areas where there may be lots of content. Activating the correct filter will help reduce confusion and show only what you need to see.
...
| Note |
|---|
The filters feature is only available inside Map Editor, Digital Sign Manager and Parking Manager. |
...
Using Filters in Map Editor
Steps
1. In the PAM navigation menu, go to 360 Studio > Map Editor
...
| Note |
|---|
If you forget to clear filters, the next time you come into Map Editor, the same filters will remain active. This means you will still see only Retail and Food Court feature types on Map Editor until you clear them. As it is easy to forget that you have filters activated, it is recommended to clear them before exiting |
...
Using Filters in Digital Sign Manager
Steps
1. In the PAM navigation menu, go to 360 Planner Studio > Digital Signs
2. Select DIGITAL SIGN MAP tab
...
| Note |
|---|
If you forget to clear filters, the next time you come into Digital Sign Manager, the same filters will remain active. This means you will only see Interactive Kiosk signs on DSM until you clear them. As it is easy to forget that you have filters activated, it is recommended to clear them before exiting. |
...
Using Filters in Parking Manager
| Info |
|---|
In Parking Manager, if you do not have a multi-level carpark feature type created in Map Editor then the filter section still appears but doesn’t do anything because there are only two possible types. Multi-level carpark and Parking You don’t need to filter anything if Parking is the only feature type being used. |
...
1. In the PAM navigation menu, go to 360 Planner Manager > Parking
2. Select the filters section on the left-hand side to open up the filters
...