Within the 3D assets section, users will be able to upload and view 3D models.
3D models can be added into dictionary items and can be viewed on the Explorer map.
Below is a table of contents to help divide the sections in this introduction for your convenience.
| Table of Contents |
|---|
...
A guide to using 3D models in PAM
Adding 3D models help create a compelling environment, but too many 3D models can be overwhelming and heavy on computational resources. Below is a guide to using 3D models in PAM.
File Requirements - Please Read
| Info |
|---|
In your account, we strongly recommend that all uploaded 3D models have a combined total of no HIGHER than 1mb 2-3mb. This means you will need to optimise the file size before uploading your 3D model into PAM. As an example, You can upload 20x 3D models that are 50kb each OR 10x 3D models that are 100kb each OR 2x 3D models that are 500kb each. This depends on your preference as long as your combined total DOES NOT go over 1mb , by reducing complexity and limiting/removing textures |
When to use 3D models
Primary Architecture/Landmarks
...
Models should be created at their actual size in a 3D editor.
The model will be positioned based on X,Y,Z axis set in the 3D software so you can position a 3D model above the ground. Note: You cannot adjust the model in the Z-axis in PAM.
Colouring the 3D model should consider the surrounding environment. You want to avoid using too many textures and colours, especially with architectural buildings. They should blend in to the environment and not conflict with ‘Extruded Shapes’
Textures on a model may be required for promotional items
Make sure textures kept to a minimum, and do not exceed 800 x 800px in dimensions
JPG medium quality OR PNG with Alpha supported
Vegetation usually requires multiple models, although there is a maximum size of 1mb for a model, the file size should be kept at a minimum when possible. (e.g. small tree was 6kb)
Models should MATCH each other
The more models you add the more computational power you need to render. Therefore if you decide to add ALL the vegetation to make it realistic, it may require hundreds of 3D models and performance could be compromised
Generally remove any detail in a model that is not required. For example in an architectural building, you only require the outer shell
...